Varifan DIP-1C, Installation & User Manual

Page: 14 / 42

DIP-1C INSTALLATION
Section B-14 DIP-1C
approximately 15 seconds. If
dNLD
is not displayed, try one more time. If
dNLD is still not displayed, remove and replace the configuration chip
(MMX).
D. When the downloading procedure is complete, remove the configuration
chip (MMX) and place it in the bottom part of the enclosure or in another
safe location. Once the MMX Chip is removed, the DIP-1C starts up and
executes the configuration.
Note: During this procedure, some components are live and can be
dangerous if touched.
Uploading the Configuration
It is possible to upload a configuration into a configuration chip (MMX) in order to
save parameters and setup or to backup the configuration.
Here’s the procedure to upload a configuration.
A. Make sure that the DIP-1C is powered up.
B. Remove the faceplate screws and lift up the cover.
C. Place the MMX chip into the socket of the main board. At this moment, the
MMX Detected parameter will appear.
D. Adjust the MMX Detected parameter to
upLD
and press the SET/CLR
button. The display on the front panel should indicate upLD for
approximately 15 seconds. If
upLD
is not displayed, try one more time. If
upLD
is still not displayed, remove and replace the configuration chip
(MMX).
E. When the uploading procedure is complete, remove the configuration chip
(MMX) and place it in the bottom part of the enclosure or in another safe
location. Once the MMX Chip is removed, the DIP-1C will continue to
execute the configuration.
WARNING: During this procedure, some components are live and can
be dangerous if touched.
www.monitrol.com