Varian Micro-GC 490-GC, User Manual

Page: 63 / 83

Reference
Varian, Inc. User Manual Micro-GC Page 55
ASSIGN NEW IP ADDRESS VIA SERIAL CONNECTION
1. Make sure this computer and the Micro-GC are connected via a serial RS232 cable
(peer to peer connection).
2. Start the Micro-GC configuration in Serial mode ( see communication setup ) on page 53
3. Click on the button “Serial Setup IP-address”, the “Serial Setup Ethernet Settings”
window appears.
4. Enter the IP address that must be assigned to the Micro-GC. This IP address must be in
the same range as the computers IP address. The three left IP segments must be
identical.
5. Enter the Subnet Mask. This will be in most cases 255.255.255.0.
6. Enter the Gateway IP address if this is required. In most small local network this is not
required.
7. Click now on the button “Assign IP address” of the “Serial Setup Ethernet Settings”
window.
8. Switch the Micro-GC off and then on again (Reboot).
9. Change the Micro-GC configuration from Serial mode to Ethernet mode and proceed as
described in the section Ethernet communication on page 50 .