VARI
❋
LITE - VL6000 B
EAM
L
UMINAIRE
Q
UICK
S
TART
G
UIDE
11
20 April 2017
02.9708.0001
Align Lamp For Maximum Beam Irradiance
After a new lamp is installed in the luminaire, it will be necessary to align the lamp to optimize the beam.
WARNING:
Back of luminaire and alignment screws will be HOT during lamp operation. Wear gloves and/or use tools to prevent burns.
AVERTISSEMENT:
Retour de luminaires et d'alignement vis sera chaud pendant le fonctionnement de la lampe. Porter des gants et / ou
utiliser des outils pour éviter les brûlures.
To align lamp:
Step
1. Set intensity to 100%.
Step
2. Position beam on a white wall at a distance of 10 to 20 feet.
Step
3. Using console or internal luminaire menu controls, focus to a hard edge. Be sure that beam-size iris is completely opened.
Step
4. Using three alignment screws (as indicated with Red Arrows in
Figure 7
) adjust hot spot to center of beam.
Step
5. Check color uniformity as follows:
a.
Position 60% magenta filter (Wheel 1) in Beam.
b.
Verify that beam color is uniform (if lamp is misaligned, color will be concentrated to one side of beam). If color is not
uniform, readjust lamp using lamp alignment screws until color is uniform across entire beam field.
Figure 7: Lamp Alignment Screws
Rear of Luminaire
Lamp (Beam)
Alignment Screws*
*Lamp Socket Cover removed
for clarity. It is not necessary to
remove Lamp Socket Cover to
align lamp.
Summary of Contents for VL6000 Beam Luminaire
Page 1: ......
Page 19: ...VARI LITE VL6000 BEAM LUMINAIRE QUICKSTART GUIDE 02 9708 0001 20 April 2017 18 Notes...
Page 20: ......
