Vari Lite VL3500 SERIES, User Manual

Page: 32 / 86

VARI ❋ LITE
®
- VL3500™ S
ERIES
L
UMINAIRE
U
SER
’
S
M
ANUAL
16 31-July-2004 02.9678.0019 0
Addressing
Program Starting Address
The address setting for DMX console controlled systems is entered using the Menu Display (refer o
“Menu Operation” on page 46 ). The luminaire retains the DMX address even if power is removed.
Note: Refer to your console operating instructions for specific information regarding s addressing
requirements.
Program a DMX starting address:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until
Address appears. Press [En er].
Step 3. Press [Up] / [Down] arrows to enter starting address
Step 4. Press [Enter] to set.
Program Starting Address Without Calibrating
Luminaire
It is possible to bypass the calibration seq ence and go directly to the Menu Display programming in
order to pre-program an address setting.
Program starting address without calibrating luminaire:
• While powering up luminai press and hold [Menu]. Program address as in Program Starting
Address above.
• Press and hold [Menu] until display changes from "Starting" to the DMX address.
Note: The lumina re will require a reset to restore control.
www.carlosmendoza.com.mx