Vari Lite VL2000, Service Manual, Page: 48 / 190

VARI ❋ LITE ® - VL2000™ S
POT
L
UMINAIRE
S
ERVICE
M
ANUAL
3 0 2 4- Ma rc h- 2 0 04 0 2 . 9 6 7 3 . 0 0 1 0 D
Yoke Assembly
This section provides removal and replacement procedures for components found in
the luminaire yoke assembly.
Tilt Motor Assembly Replacement
Parts:
22.9661.0665 1 EA ASSY, TILT MOTOR
Tools:
Screwdriver, #2 Phillips
Nutdriver, 1/4"
To replace tilt motor assembly:
Step 1. Disconnect luminaire AC input cable from power source.
Step 2. At tilt-side leg, remove yoke leg cover by removing four (two on each side)
6-32
×
5/16" PPB screws. Figure 2-17 . To find tilt-side leg, refer to page 8 .
Figure 2-17: Tilt Motor Assembly Replacement
Step 3. At pan/tilt encoder PCB (mounted behind tilt motor mounting plate), discon-
nect two cable connectors.
Step 4. At tilt motor, disconnect motor wire connector.
Yoke Leg Cover
Tilt Motor Assembly
6-32
×
5/16"
PPB Screw
Standoff
Cable Anchor
6-32
×
5/16" PPZ Screw