Varec 2500, Installation And Operation Manual

Page: 25 / 124

Varec, Inc. 15
Table 5: Cone Roof Tank and Internal (Floating Roof) Pan: No Floatwell — Installation Checklist
Tank Top Mounting
Order Code T04, T14, T24, T32
Installation parts supplied include:
•
Gauge 'U' bolt kit
•
Guide Wire bottom anchor
•
Guide Wires
•
gauge head and tape
•
Float
•
Guide Wire top anchors (x2)
•
Tape connectors
Figure 9: Tank Top Mounting
Installation Checklist
When installing a 2500 ATG system on a cone roof tank, complete each installation step below.
Check off a step when it is complete. Refer to Section “Installation Schematics” on page 21 for
overall dimensions.
Step Description Complete
1 “Tank Roof Entry - Internal Pan (Floating Roof)” on page 24
2 “Installing Support Brackets & Pipework” on page 27
3 “Installing a Gauge Head at Grade Level” on page 28
4 “Connecting the Cable to a Floating Pan” on page 33
5 “Feeding the Tape to a Gauge Head Located at Grade Level” on page 34
6 “Install Tape in the Gauge Head” on page 35
7 “Reset the Counter” on page 40
8 “Calibrate the Counter” on page 41
9 “Initial Lubrication” on page 42
10 “Install a Transmitter and Replace all Covers” on page 42
11 “Initial Operation” on page 43
Step Description Complete
1 Section “Tank Roof Entry - Cone Roof Tank” on page 23
2 Section “Installing Anchors and Guide Wires” on page 25
3 Section “Installing a Roof Reading Gauge Head” on page 29
4 Section “Float installation on an Out-of-Service Tank” on page 30