Varan Motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
T: 00352/26908036 – F: 00352/26908040
JHS-1100
OPERATION
•
Mark the wall surface to be slotted
•
Hold front handle with left hand and rear handle with right hand
•
Make the front rollers touch the wall surface and raise the rear rollers to make sure there is a
narrow gap between surface and cutter
•
Start the Wall Chaser and hold it firmly to avoid initial vibrations
•
Push the rear handle to make the cutter cut into the wall slowly
•
Right arm lean on to the Wall Chaser and push the Wall Chaser move forward
•
Move the Wall Chaser across the surface at a constant speed
•
Do not force the Wall Chaser
TO START THE WALL CHASER
•
Open box, take out Wall Chaser
•
Install Cutter
•
Connecting the Wall Chaser with a vacuum cleaner
•
Put on the safety goggles
•
Plug in the Wall Chaser
•
Press the anti-lock button with thumb and hold it
•
Press the ON/OFF switch, now the Wall Chaser is running
INSTALL CUTTER
Install Cutter step by step as follows:
•
Ensure the Wall Chaser is unplugged from mains power
•
Place a washer between the shaft and cutter. It will ensure perfect seating on the shaft and make
it easier to remove the cutter after use.
•
Screw the cutter to tight
HOW TO USE
