
2.
Battery and Charger:
The VP2 uses a special 3.6V lithium AA 14500 battery. This Battery and the Charger that comes with it
are unique to The VP2 cannot be replaced with conventional batteries or chargers. Please be sure to
check the locally-available voltage if traveling to make sure you do not damage the original Battery or
Charger.
Assembly
Assemble the VP2
Step 1: Install a charged Battery into the unit with the (+) end in first.
Step 2: Install the Atomizer by screwing onto the brass fitting on the battery housing.
Step 3: Fill a cartridge by pushing the fiber down into the white cap with a paper clip or similar device.
Fill to top, then lift fiber up to rim of white cap housing. Cap off and install in atomizer. This method is
called capping off; another method is dripping 2-4 drops into the atomizer and just using the black tip.
The white part of the cartridge pops off to use just the tip.
Step 4: Slide the Atomized Refill piece onto the Atomizer and press it down firmly. You are now ready
to enjoy The VP2 Cig.
Caution: Always hold atomizer
when removing cartridges. This is true for all E cigs, the reason is to
protect the pressed parts from loosening while trying to install or remove atomizers.
Operation of The VP2:
The VP2 will turn on only while you press the push button, and will immediately turn off after releasing
the button. The indicator light will light up while the button is pressed. It is recommended that The E
Cig not be held in an upside down position for any extended period of time since doing so may cause
the liquid in the Atomizer to flow out into the user’s mouth upon the next use. Try to keep the VP1 flat
or with the tip in the up position.
Smoking The VP2:
Typical smokers inhale anywhere from 7-12 drags on their traditional cigarette, so after taking 7-12
drags of The E Cig it is recommended the user take a 30 minute break before using again. Determining
the optimal number of drags and usage times will vary from user to user and you will have to determine
the right number and usage times for yourself.
How to use
Please Note:
1. to avoid over-usage do not exceed 16 drags within one minute, if you do, the Atomizer can get
extremely hot, and will shorten the life of the atomizer.
2. When the Battery is low the indicator light will become dim and you will need to recharge the
Battery or swap it for a fully-charged one.
The Atomizer is the part that creates the vapor and is the heat source for your E Cig. Imagine a light
bulb that gets too much electricity going through it. As you increase the electricity the bulb will burn
out. In similar fashion if you take very hard and constant drags on The E Cig eventually the Atomizer
might also burn out. In order to prevent this it is highly recommended that you take slower and longer