Fig. 7
Fig. 8
The red light will illuminate when the power button is
depressed indicating the unit is heating. The green light
will illuminate indicating the unit is fully heated and
ready for use (approximately 11 minutes). The green
temperature during use. (Fig. 10)
Fig. 9
Fig. 10
Green
light
Red
light
Fig. 11
!
er fill
NOTE:
Do not ov
!
!
!
outlet. Allow steam cleaner to cool down before removing water tank cap. Unscrew the
water tank cap (Fig. 7) by pressing the cap down and simultaneously turning counter
Replace the water tank cap by pressing down on the cap
and simultaneously turning it clockwise. Make sure the
cap is fully tight to prevent any steam from leaking out.
and once cooled down tighten cap further.
Always use the dipstick to check the
Plug the
or
FILLING & OPERATION
Release the locking device (child - proof
device) by sliding the lock down away from the trigger.
(Fig. 11)
Once the green light illuminates the
steamer is ready for use. The green and red light will
continue to use the steamer as you normaly would
!
clockwise. Check the water level with the supplied dipstick. Use the supplied funnel
equal 1400ml /1.4 liters. (Fig. 8)
Dip
stick
1400ml / 1.4 liters. If so turn the machine over and
remove water to adjust water level.
!
Make sure steamer is completely cooled
the cap while the steamer is hot can cause scalding
and severe burns.
(Fig. 9)
The dipstick has
3 marks, F is full 1400ml, apox. 1 hour steam time - H is
half full 700ml, aprox. 30 min steam time - L is low
200ml, aprox. 10 min steam time.
Summary of Contents for MP-100 Primo
Page 1: ......
