Vante SEBRA MINI 2380, Operation Manual

Page: 19 / 33

13
P/N VT-108723-US, Manual revision: C Vante
®
SEBRA
®
MINI
™
Tube Sealer Power Source
Setup and sealing procedure
1. Remove the components from their protective shipping containers and
visually inspect them for obvious damage. Contact Vante
®
Customer
Care Center if any damage is found.
Note: If possible, retain shipping containers and packing materials for future
use.
2. For optimal performance, batteries should be fully charged prior to use.
3. Check to see that the power switch is in the off position. Open the battery
compartment door on the power source case by sliding the latch to the
right. See 3-1.
Figure 3-1, Opening Battery Compartment Door
4. Position the battery connector as shown in 3-2.
Caution: Use only with battery packs equipped with a Positive Thermal Cutout
(PTC) device and approved for use with Vante
®
SEBRA
®
Model 2380
MINI™.
Chapter 3