VANNER
Incorporated
Owner’s Manual
VTS Series 1500Watt 7 True Sine Wave Inverter/AC transfer Switch
3. Installation and Operation
This inverter is one of the most advanced lines of mobile AC power systems. For best performance the inverter
must be installed and used properly. Please read this instruction manual before installing and operating the inverter.
3-1. Front Panel Area:
AC INPUT
BREAKER
S S S S
0
1
P
W
R
.
S
A
V
.
F
R
E
Q
.
1 2 3 4
P
O
W
E
R
S
T
A
T
U
S
IN
P
U
T
L
E
V
E
L
L
O
A
D
L
E
V
E
L
PORT
REMOTE
G
N
D
E
N
B
E
N
B
POWER
ON-OFF-REMOTE
DC INPUT
POS(+)
NEG(-)
REVERSE POLARITY
WILL DAMAGE UNIT
3-1-2. ON / OFF/ REMOTE (Main) Switch:
Before installing the inverter, be sure the main rocker switch is set to “OFF”.
Before using the remote, you need to ensure the main switch is in the “REMOTE” position.
3-1-3. AC Input Circuit Breaker:
The AC input circuit breaker protects the unit from overload. When an overload condition exists, the circuit
breaker will trip. To reset push the breaker switch, the unit will resume normal operation.
3-1-4. Remote Port: The modular jack labeled Remote Port is not used.
3-1-5. Remote Control Connector:
(The Remote Control Connector is enabled when the ON/OFF/Remote main rocker switch, is in the
Remote position.) This three-position connector, Phoenix part number 1911868, is labeled GND, ENBBAR,
and ENB. Use this connector with a customer supplied SPST switch to provide remote ON/OFF control of
the inverter. Remote switch circuit arrangement options are +12v to ENB, or Battery Negative to ENBBAR,
or GND to ENBBAR. The most common application (+12v to ENB) uses a +12v hot-in-run from vehicle
fuse panel to turn inverter ON when vehicle is ON, and OFF when vehicle is OFF.
