Owner's Manual
VCS12/24 Battery Charger
Page 10
The switches locations are as shown below:
heatsink
fan end
switches
heatsink
ABCD
The switches are the rectangle next to the lower heatsink approximately midway
between the two large transformers.
The 4 ways are designated A through D, left to right, viewed as in the above
diagram.
The charger is supplied with all switches in the “off” position (switched towards
the adjacent heatsink). This sets the output to 24V nominal in charger mode.
To set the output to 12V nominal, charger mode, set switches A & B to the “on”
position (switched away from the adjacent heatsink).
WARNING: switches A & B must always be both “on” or both “off”.
To change from charger mode to power supply mode, set switch C to the “on”
position (switched towards the adjacent heatsink). This operates in both 24V &
12V modes.
Switch D is not used.
WARNING: connecting a 12V battery to the 24V output can cause serious
damage, fire & injury.
