background image

 V-SIX SE

120V

25799 Jefferson Ave.  

 

 Murrieta, CA 92562 

 

 

 

1-800-VANIMAN (826-4626) 

 

 

 

www.vaniman.com

  

  

[email protected]

10281-02/22 PAGE 1

PACKING LIST

 

 

 

1 - V-Six SE Dust Collector

 

1 - Power Cord

 

1 or 3 - Port Caps (Dependant on Inlet Plate Model)

ASSEMBLY INSTRUCTIONS

1.  Remove the Unit and other parts from the packaging and check against the packing list above.
2.  Open the front door of the unit to access the filter compartment cover plate. Remove the four black 

thumb screws and remove the cover plate. Locate the wing nut at the bottom of the cartridge filter and 

check to make sure it has not come loose during shipping. Tighten if necessary. 

3.  The V-Six requires a dedicated 120 volt, 15 amp, 50/60 Hz. circuit. Plug the removable power cord into 

the socket on the back of the unit. Plug the other end into a wall outlet that will support the electrical 

needs, then flip the Main Disconnect Switch on the back of the unit into the 

ON

 position. Once the unit 

is supplied power, confirm on the Control Panel (front of unit) that the red 

POWER ON/OFF

 indicator 

light is on solid. If the indicator light does not come on after flipping the Main Disconnect Switch to the 

ON

 position, check that the Power Cord is properly and securely plugged into the unit and the wall.

4.  The Air Blast filter cleaning system requires compressed air to operate. Connect a 1/4 inch NPT male 

connector air fitting to the brass female connector located on the back of the unit. 

DO NOT 

supply 

more than 100 PSI to unit.

IMPORTANT SERVICE INFORMATION:

SAVE  SHIPPING  BOX AND  FOAM  FOR  FUTURE 

SERVICE.  SHIPPING WITHOUT PROPER FOAM 

MAY CAUSE DAMAGE TO UNIT

Summary of Contents for V-SIX SE








Reviews: