1
2
3
4
PURE BREEZE FX
FUME EXTRACTOR
25799 Jefferson Ave. ● Murrieta, CA 92562 ● 1-800-VANIMAN (826-4626) ● www.vaniman.com ● [email protected]
10380-12/21-PAGE 2
Replacement Parts
Fig. #
Description
Part Number
1
Caster Wheels
3140
2
Extra Rigid Capture Hose
96101
3
Nozzle (5 Pack)
96102
4
Foot Remote/Bellows
1443
ASSEMBLY INSTRUCTIONS
1. Once the unit is removed from its packaging, remove the four caster wheels from the bag packed with
the power cord. Lay the unit on its back on top of several pieces of foam packaging to protect it. Screw
the four caster wheels into the four threaded holes in the bottom of the unit. Use the supplied Spanner
Wrench to tighten the caster wheel to the case, BUT DO NOT OVER TIGHTEN.
2. Remove the four thumb screws on the front of the unit, as well as the filter cover panel to expose the
HEPA and Charcoal Odor Filter inside the unit. Remove both filters from the unit, and then remove
the plastic packaging from both of the filters. Return the filters back into the unit it the correct order
with the Charcoal Odor Filter sitting on top of the HEPA Filter. Replace cover panel and thumb screws.
3. Connect the Extra Rigid Capture Hose to the top of the unit by sliding the black hose adapter onto
the inlet tube (only one end of the hose will fit). Slide nozzle into opposite end of the hose and lock it
by twisting the nozzle clockwise until you feel a click. Adjust the hose to the desired position. If your
hose losese rigidity and is struggling to stay in the desired position, add rigidity by holding the hose
firmly with one hand and twisting the hose in the counter clockwise direction (with regards to looking
down the hose). Keep twisting until the hose reaches the desired rigidity. If the hose is twisted in the
wrong direction, the hose will begin to bulge in that area and become even less rigid. If continued the
hose will break.
4. Plug one end of the removable power cord into the socket labeled “Power Cord” on the side of the
unit, and the other end into a standard grounded wall socket. Test the unit by flipping the
On/Off
switch
into the
On
position.
NOTE:
If using the On/Off switch to turn the unit On, you MUST use the same
switch to turn the unit Off.
IMPORTANT SERVICE INFORMATION:
SAVE SHIPPING BOX AND FOAM FOR FUTURE
SERVICE. SHIPPING WITHOUT PROPER FOAM
MAY CAUSE DAMAGE TO UNIT
PACKING LIST
1 - Pure Breeze FX Fume Extractor
1 - Extra Rigid Capture Hose
1 - Nozzle
1 - Power Cord
4 - Caster Wheels
1 - Foot Remote/Bellows