12
105605
UNVENTED (VENT-FREE) LOGMATE
®
FIREBOX
VANGUARD
2.
Remove the screw and retainer bracket
at the top of the brick liner panel in the
back of the firebox. Do not let the panel
fall after the bracket is removed. Care-
fully remove the rear firebrick liner
panel from the firebox.
INSTALLATION
Continued
Figure 19 - Removing Rear Firebrick Liner
Panel
CAUTION: Do not let the fire-
brick liner panel fall after the
bracket is removed.
3.
Carefully lift and remove the bottom
firebrick floor from bottom of firebox.
4.
Remove the four Phillips screws in fire-
box bottom.
Figure 20 - Removing Bottom Firebrick
Floor
Screw
Rear Firebrick
Liner Panel
Bracket
Figure 17 - Installing Plastic Bushing for
Power Cord
1
1
/
2
" Hole
Plastic
Bushing
Plastic
Hole Plug
Figure 16 - Mounting Blower to Firebox
Blower
Screws
Lower Rear Wall of
Firebox Wrapper
Top
Mounting
Tab
Exhaust Port
3.
Place the blower against the lower rear
wall of the firebox outer wrapper with
the exhaust port directed upward. Align
the holes in top mounting tabs of blower
with holes in wall of wrapper (see Fig-
ure 16). Using 2 screws provided, mount
blower and tighten screws securely.
4.
Be certain that all wire terminals are
securely attached to terminals on
blower motor and that the screw retain-
ing the green ground wire is tight.
5.
Locate the plastic hole plug installed
in the 3/8" diameter opening in the
lower right side of the firebox front
panel (see Figure 17). Remove the
plastic plug and discard.
HARD-WIRING FIREBOX
For Built-in Installation of
Circulating Models Only
NOTICE: A qualified electrician
must connect electrical wiring
to duplex outlet for built-in in-
stallation. Follow all local
codes. In absence of local codes
follow
The National Electric
Code ANS/NFPA 70.
Models FB36CB, NLFB36C, and FB42CA
can be hard-wired to the duplex outlet lo-
cated inside the firebox bottom if desired.
This allows the GA3700 Blower Accessory
to be plugged into the duplex outlet.
1.
If your firebox has a brick liner use a
Phillips screwdriver, remove the screw
and retainer bracket at the top of the
firebrick liner panel on the left side.
Carefully remove the left panel from
the firebox. Repeat for firebrick liner
panel on right side.
Figure 18 - Removing Side Panel
Retainer
Bracket
Left Side Firebrick Liner Panel
Screw
Product
Identification
Label
