VG-LM150S 150W LED Moving Head Spot Light User Manual VG-LM150S 150W LED Moving Head Spot Light User Manual
2. DMX connection
Connect the provided XLR cable to the female 3-pin XLR output of your controller and the
other side to the male 3-pin XLR input of the moving head. You can chain multiple Moving
head together through serial linking. The cable needed should be two core, screened cable
with XLR input and output connectors. Please refer to the diagram below.
For installations where the DMX cable has to run a long distance or is in an electrically noisy
environment, such as in a discotheque, it is recommended to use a DMX terminator. This
helps in preventing corruption of the digital control signal by electrical noise. The DMX
terminator is simply an XLR plug with a 120 Ω resistor connected between pins 2 and
3,which is then plugged into the output XLR socket of the last fixture in the chain. Please
see illustrations below:
For installations where the DMX cable has to run a long distance or is in an electrically noisy
enviroment, such as in a discotheque, it is recommended to use a DMX terminator. This
helps in preventing corruption of the digital control signal by electrical noise. The DMX
terminator is simply an XLR plug with a 120 Ω resistor connected between pins 2 and 3,
which is then plugged into the output XLR socket of the last fixture in the chain. Please see
illustrations below.
.
Ⅵ
OPERATION AND CONTROL
1. Control panel
Display:
To show the various menus and the selected functions
LED:
POWER
ON
Power on
06
07
