43
Mounting the input PCB
:
1-a) Check the PCB for long protruding leads - trim if necessary.
1-b) This PCB is mounted with two different types of screw: four self tapping screws into the
cinch input terminals through the back of the chassis, and two M3x5 screws onto the
supports inside the chassis.
1-c) First fix the input terminals with the four black self tapping screws from outside the chassis.
1-d) Place two nylon washers between the PCB and the M3 supports mounted at the base of
the chassis. This will lift the PCB by 1.5mm so the input selector and its extension shaft will
fit well. These washers are in your parts kit. Now fix the PCB with two M3x5 screws, taking
care not to over tighten these.
Mounting the line- and MD circuit boards.
2-a) First check for any excessively long leads protruding from the board
2-b) Now fix in place with M3x5 screws.
Phono ground terminal.
3) An M3 knurled thumbscrew is supplied with your kit. Screw it into the GND terminal at the
back of the chassis. (see figure 28 “ground screw”) This screw is used to attach the ground
lead of your record player.
Interconnection of the audio boards.
4) Please refer to figure 28. You will notice ten short interconnecting wires between the audio
PCB’s displayed in red. Please use short pieces of the supplied non insulated wire for
these. Form little arcs from this wire ensuring that they don’t touch the adjacent wires.
5) Displayed in green you will notice the safety GROUND lead between the input PCB and the
ground terminal next to the mains input terminal. Take a piece of 7 cm of the green/yellow
striped wire. Feed it through the hole in the partition and mount both sides very carefully,
remember first hook it in, bend flat and then solder carefully. Connection of this wire is very
important for safety reasons, please pay attention to this.
Summary of Contents for MCML05
Page 4: ...4 EG verklaring ...