Fold
Fold
19 Model Seven Operation Manual
U
NPACKING
A
ND
R
EPACKING
T
HE
M
ODEL SEVEN
At least two people are required to unpack or pack a pair of Model Sevens. Each
speaker is shipped on its own pallet and has a gross weight over 220 pounds. Please
use the handholds in the boxes and proper lifting techniques to lift and move the
speakers.
There could be grease or dirt on the bottom of the pallet. Cover carpet with several
layers of newspaper or an old blanket before you set the pallet down.
The speaker must remain up-right as it is unpacked. Do not tilt the pallet to access
the securing bolts or remove the box.
U
NPACKING
I
NSTURCTIONS
1. Cut the tape around the top of the box at all four cor-
ners.
2. Lift up each of the top flaps to release the main box
flaps that were anchoring the top in place and lift the
top off.
3. Lift the cardboard grille cover/spacing collar up and off
the speaker.
4. Cut the tape around the bottom of the box at all four
corners.
5. Pull out the bottom flaps to release the main box
R
EPACKING
I
NSTURCTIONS
The Model Seven must be bolted to its pallet and prop-
erly packed in its original box prior to shipment.
1. With one person supporting the body of the speaker,
carefully lean the speaker to the sides and remove the
cones from the bottom.
2. Gently lift the speaker and set it on the pallet inside the
cardboard recess.
3. Insert the two shipping bolts with washers through the
pallet and into the speaker. Tighten the bolts just one
turn past finger tight.
4. Pull flannel sock and the plastic bag over the speaker.
5. Slide the main box down over the speaker. Secure the
main box flaps inside the bottom flaps as shown in the
illustration. Run reinforced tape around the bottom to
hold the flaps tight against the box.
6. Slide the grille cover/spacing collar over the speaker.
7. Place the top on the box and secure the main box flaps
inside the top flaps as shown in the illustration. Run
reinforced tape around the top to hold the flaps tight
against the box.
flaps that were holding the bottom and the main
box
together and lift the main box up and off the
speaker.
6. Lift the plastic bag and flannel sock off the speaker.
7. With allen wrench provided, reach through the open-
ing in the pallet and remove the two bolts attaching
the speaker to the pallet.
8. With the help of at least one other person, lift the
speaker off the pallet and set it on a soft surface. Do
not use the grille frame to support the speaker.
Please keep the boxes, pallets and hard-
ware. Replacement boxes and pallets must
be shipped by truck and will cost at least
$450.00
Tape
Main Box
Spacing Collar
Tape
Allen Bolt
Model
Seven
