System Menu Configuration
© Vanderbilt 2017
34
RS-485/RS-422 Settings
You can connect the analog dome or DVR with the keyboard via RS-484 serial port, and the MAG with
keyboard via RS-422 serial port.
Select
RS-485/RS-422
to enter the RS-485/RS-422 settings interface. You can configure the address bit (RS-
485 only), baud rate, data bit, protocol (PROT: PELCO-P, PELCO-D, VICON, KALATEL, HIKVISION-C
selectable), stop bit, parity, and copy all settings. When you set the Copy All to Yes for RS-485 serial port, the
current settings will be copied to the connection of all other RS-485 devices.
Click
OK
button or the central button of joystick to save the settings.
Figure 7-3
RS-485 Settings
The RS-485/RS-422 parameters configured here must be the same with the connected dome/DVR or MAG.
Hardware
You can set the auto-logoff feature of the keyboard.
Select
Hardware
to enter the following interface, and move (left/right) the joystick to set the
A-Logoff
to ON or
OFF. Click
OK
button or the central button of joystick to save the settings.
When the auto-logoff is set to ON, the system will automatically log off after the device is not operated for 30
minutes.
Figure 7-4
Auto-Logoff Settings