www.vanco1.com
888.769.4156
5
CONNECT AND OPERATE
1. Connect 1 source such as a Blu-Ray Player, game console, A/V Receiver, Cable or Satellite Receiver, etc.
to the HDMI input on the transmitter balun.
2. Connect 1 display such as an HDTV or HD Projector to the HDMI output on the receiver balun.
3. Connect a single Category 5e/6/7 up to 131 ft (40m) to both transmitter and receiver baluns.
4. Plug in the IR receiver to the (IR RX) jack port located on the Receiver balun. The IR receiver is the larger
and rectangular shaped emitter; place this IR receiver at a desired place that will receive a remote signal.
5. Plug in the IR transmitter to the (IR TX) jack port located on the Transmitter balun. The IR transmitter is
the smaller, and rounded at the end emitter, place in front of the IR receiver of the source, ensure that the
emitter is placed in front of the IR receiver eye.
6. For power, plug in the source first, followed by the Vanco Powered by Wyrestorm Extender Receiver and
then Transmitter (2 5V DC power supplies included), followed by the output connected.
7. Power on each device in the same sequence (receiver and transmitter will already be powered when
plugged in.
At this point the display connected should display the source signal connected to the extender set. If no signal
is being displayed, connect a shorter Cat5e/6/7 cable (less than 15 ft). If no signal is still displaying, adjust
the DIP switch for EDID, if a signal displays with the shorter category cable, the EQ distance will need to be
adjusted to the longer category cable being used. Use the source remote at the receiver emitter to test IR
functionality. If a display is having difficulty receiving a signal after adjusting EDID and distance, access the
display’s menu and adjust the resolution (lowest to highest until signal is displayed). A 24 Hz vertical refresh
rate may work better than 60 Hz or higher. If the IR remote function is not responding, check the emitters to
ensure they are placed correctly and are plugged into the correct IR jacks on the Extender set receiver and
transmitter baluns.
Cat5e/Cat6 Cable
