www.vanco1.com
800.626.6445
7
CONNECTION DIAGRAM
CONNECT AND OPERATE
1.
Connect a source such as a Blu-Ray Player, game console, A/V Receiver, Cable or
Satellite Receiver, etc. to the HDMI input on the Transmitting unit.
2.
Connect a display such as an HDTV or HD Projector to the HDMI output on the
Receiving unit.
3.
Connect a single Category 5e/6/7 up to 230ft/70m to the HDBaseT output of the
Transmitting unit, and the other end to the HDBaseT input of the Receiving unit.
4.
For power, plug in either the Transmitting unit or Receiving unit with the included power
supply, opposite unit will not have to be plugged in as it features Power over Ethernet
(PoE).
5. Power on each device in the same sequence (receiver and transmitter will already be
powered when either unit is plugged in.)
At this point the display connected should display the source signal connected to the extender set. If no
signal is being displayed, connect a shorter Cat5e/6 cable (jumper or patch cable). If a display is having
difficulty receiving a signal, access the display’s menu and adjust the resolution (lowest to highest until signal
is displayed). A 24 Hz vertical refresh rate may work better than 60 Hz or higher. Use the source remote at
the receiver emitter to test IR functionality. If the IR remote function is not responding, check the emitters to
ensure they are placed correctly and are plugged into the correct IR jacks on the Extender set receiving and
transmitting units.
