www.vanco1.com
800.626.6445
13
CONTROL LOCAL DEVICE REMOTELY
Connect IR receiver(s) to IR IN on far-end HDBT receiver(s), and IR Emitter(s) to IR OUT port of the switcher,
and use the IR Remote of local source to control the device remotely.
1 to 1:
Connect an IR receiver to IR IN on far-end HDBT receiver, and an IR Emitter to IR OUT port of the switcher.
Use the IR Remote of local source to control the device remotely. See below:
Note: Send command “%0901.”to enter infrared carrier enforcing mode if the IR Receiver connected to IR IN
of the receiver is not with carrier.
MULTIPLE TO MULTIPLE: (IR Matrix)
The 4 “IR OUT” ports and the 4 “IR IN” ports on the far-end receivers make up an 4x4IR matrix. See as below:
The IR signal is sent by corresponding IR remote, then it is transferred to HDBaseT receiver, then to
corresponding zone of the matrix through the twisted pair, finally it is transferred to IR OUT port and received
by controlled device.
