www.vanco1.com
800.626.6445
7
CONNECTION DIAGRAM
CONNECT AND OPERATE
1. Connect a source such as a Blu-Ray Player, game console, A/V Receiver, Cable or Satellite Receiver, etc.
to the HDMI input on the Transmitting unit.
2. Connect a display such as an HDTV or HD Projector to the HDMI output on the Receiving unit.
3. Connect a single Category 5e/6/7 up to 164ft/50m to the UTP output of the Transmitting unit, and the
other end to the UTP input of the Receiving unit. A home-run category cable is strongly recommended,
any coupling point results in signal loss that could affect the video signal. Patch panels are not
recommended as they can slightly change the frequency of the signal.
4. For power, plug in either the Transmitting unit or Receiving unit with the included power supply, opposite
unit will not have to be plugged in as it features Power over Ethernet (PoE).
5. Power on each device in the same sequence (receiver and transmitter will already be powered when either
unit is plugged in.)
At this point the display connected should display the source signal connected to the extender set. If no signal
is being displayed, connect a shorter Cat5e/6 cable (jumper or patch cable). If a display is having difficulty
receiving a signal, access the display’s menu and adjust the resolution (lowest to highest until signal is
displayed). A 24 Hz vertical refresh rate may work better than 60 Hz or higher. Use the source remote at the
receiver emitter to test KVM functionality. If the KVM remote function is not responding, check the emitters to
ensure they are placed correctly and are plugged into the correct KVM jacks on the Extender set receiving and
transmitting units.
