www.vanco1.com
800.626.6445
7
CONNECTION DIAGRAM
CONNECT AND OPERATE
1.
Connect a source such as a Blu-Ray Player, game console, A/V Receiver, Cable or
Satellite Receiver, etc. to the HDMI input on the Transmitting unit.
2.
Connect a display such as an HDTV or HD Projector to the HDMI output on the
Receiving unit.
3.
Connect a single Category 5e/6/7 up to 330ft/100m to the HDBaseT output of the
Transmitting unit, and the other end to the HDBaseT input of the Receiving unit.
4.
For Boost feature, connect a single HDMI cable to the HDMI ports on the Transmitting
and Receiving units. (HDMI ports for Boost transmission are located next to the
HDBaseT RJ45 jacks). HDBaseT over Cat5e/6 and Boost over HDMI transmission
cannot be utilized simultaneously.
5.
For power, plug in the Transmitting and Receiving units with included DC 5V 2A power
supplies.
6. Power on each device in the same sequence (receiver and transmitter will already be
powered when either unit is plugged in.)
At this point the display connected should display the source signal connected to the extender set. If no
signal is being displayed, connect a shorter Cat5e/6 cable (jumper or patch cable). If a display is having
difficulty receiving a signal, access the display’s menu and adjust the resolution (lowest to highest until signal
is displayed). A 24 Hz vertical refresh rate may work better than 60 Hz or higher. Use the source remote at
the receiver emitter to test IR functionality. If the IR remote function is not responding, check the emitters to
ensure they are placed correctly and are plugged into the correct IR jacks on the Extender set receiving and
transmitting units.