Vancare VERA-LIFT II B350, Maintenance Manual

Page: 16 / 65

Technical instructions Control unit Mobilette
531e2931_0101 Magnetic – The Linear Drives Company™ page 6/11
Connecting the actuator(s)
Insert the actuator plug into the corresponding socket
o
on the control unit (Fig. 5).
Then proceed as follows:
c
Insert the plug (the sealing rings must not be visible)
Ensure that the groove on the plug is aligned with the mark on the control unit.
d
Use the special plug disassembling tool No. 140375 to turn the plug approx. 30°
to the right up against the stop in order to lock it in position.
Repeat steps
c
to
d
if you wish to connect an (optional) second actuator.
Otherwise, the actuator output which is not used is closed with a watertight blanking
plug at the factory. This plug must not be removed.
3.5 Startup
Charging the battery
The battery charging process is started when the mains adapter / mains cable is
plugged in, or the battery pack is fitted in place while the mains adapter / mains cable
is plugged in.
An LED (Fig. 8,
c
) indicates the battery’s charge state
LED yellow Batteries are being charged, mains voltage connected.
LED green Batteries are fully charged, mains voltage connected.
LED unlit Mains voltage not connected.
Current consumption at full load
During commissioning, measure the actuator’s maximum current consumption at full
load. It must not exceed the value specified on the type plate of the linear actuator.
Higher current consumption means that the linear actuator is overloaded and may be
damaged.
An integrated overcurrent cut-off automatically deactivates the actuator if the cur-
rent consumption is too great.
Fig. 7 – Inserting the actuator plug
Batteries must only be charged in well-venti-
lated rooms. The gases resulting from the
charging process are dangerous.
Do not charge the batteries in damp environ-
ments!
If the charging cycle lasts more than 20
hours, the battery or control unit is faulty.
Remove the mains adapter from the socket.
(See also 5.1 Maintenance)
Lightly lubricate the plug sealing rings with
Klübersynth VR-252, Magnetic order No.
R50014.
The use of other lubricants can damage seal-
ing rings and the plastic housing.
Ensure that the groove on the plug is aligned
with the mark on the housing.
Otherwise, the plug cannot be connected
properly.
1
Fig. 8 – LED for battery charge status
During charging, any lifter controlled by the
MOBILETTE must not be used.
Wait until the charging process is over before
using the MOBILETTE.
February 2008 For your nearest Distributor, call 1-800-694-4525 16