SECTION 6: MAINTENANCE
AIR N ARC
®
300 SERIES ALL-IN-ONE POWER SYSTEM
®
PAGE - 72
090034-OP_r0
6.4 REPLACEMENT PARTS
Replacement parts should be purchased through your
local Vanair representative or where the 300 Series
Power System was purchased. If, for any reason, parts
are not available in this manner, they can be purchased
through Vanair directly.
VANAIR MANUFACTURING, INC.
10896 West 300 N.
Michigan City, IN 46360
Telephone: (800) 526-8817
(219) 879-5100
Service Fax: (219) 879-5335
Parts Fax: (219) 879-5340
Sales Fax: (219) 879-5800
www.vanair.com
6.5 MAINTENANCE ACCESS
The maintenance requirements of the Air-N-Arc 300
Series machine package can be accessed via the top
hood.
NOTE
For assistance when ordering new
replacement parts, consult
Section 9.1,
Parts Ordering Procedure
, and Table 9A:
Recommended Spare Parts List.
MAINTENANCE ISSUE
SECTION
LOCATION
Compressor oil filter (easier to access with
panels removed)
6.6.4
Oil Filter Change
I
Belt Replacement
I
Pressure Switch Adjustment
6.6.13
Main Cooler Assembly Cleaning (thorough)
6.6.11
Replace Fuses and Circuit Breakers
6.7
Generator Fuse Replacement
6.7
I
Refer to the Motor Operator’s Manual.
NOTE
If additional spare parts are being stored
for future use, make certain that they are
stored in proper containers that allow for
protection against contamination, and
kept in a clean area of moderate
temperature reading. For information on
storing the machine package for periods
of non-use, consult
Section 6.8.2, Long
Term Storage
.
CAUTION
For safety reasons and to lessen the
possibility of damage, a minimum of two
personnel should handle the actual
removal of the maintenance access
panel assembly from the base frame.
WARNING
Relieve pressure from the compressor
system before removing any
components. The compressor oil level
should be checked with the unit shut
down and the oil allowed to properly
settle.
