AIR N ARC
®
300 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 5: OPERATION
090034-OP_r0
PAGE - 55
5.2.2 MACHINE SHUTDOWN
Consult
Figure
5-1
. To shut the machine off at any time,
turn the machine control switch to the
OFF
position.
However, this method is best reserved for emergency
shutdown situations only. Vanair
®
recommends that the
following procedure is used for routine shutdowns in
order to keep the system in optimal condition, and
minimimize undue stress that may occur during the next
start up session if some of the machine conditions were
left in working mode(s) or had auxiliary power draws left
intact (such as a tool receptacle left plugged into the
generator, etc.).
To prepare the machine for shutdown:
NOTE
Refer to Truck Operator’s Manual for
additional information pertaining to the
starting of the truck.
CAUTION
Compressors and motors generate heat
and create hot surfaces. Use caution
when operating and servicing
equipment. Some surfaces and
components may be hot.
Figure 5-3: Start-up Function Conditions
A
A
B
A
