AIR N ARC
®
300 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 2: DESCRIPTION
090012-OP_r0
PAGE - 31
2.6.3 DC CHARGER MODE TOGGLE SWITCH
The three-position
DC charger mode toggle switch
lets
the operator choose the type of charge needed from 12V
center (default), 12V boost or 24V boost options. This is
a momentary switch; the lights will indicate the mode
selected.
2.6.4 VOLTS/AMPS MANUAL ADJUSTMENT DIAL
The
volts/amps manual adjustment dial
allows the
operate to manually increase or decrease the amount of
amperage or voltage, in variable increments, for the
desired weld heat.
2.6.5 COMPRESSOR ON/OFF TOGGLE SWITCH
The
compressor ON/OFF toggle switch
engages the
air compressor system. This machine utilizes an
electronic clutch to engage the compressor.
2.6.6 COMPRESSOR AIR PRESSURE GAUGE
The
compressor air pressure switch/gauge
indicates
the discharge air pressure.
2.6.7 WELDER LEAD JUNCTION
The
welder lead junction
contains the positive and
negative interface connections for the standard welding
lead cable.
2.6.8 BATTERY CABLE RECEPTACLE
The
battery cable receptacle
junction contains the
interface connections for the battery cables when
charging the battery from the DC charger. The battery
cable receptacle contains a weather-resistant cap.
2.6.9 GENERATOR CONTROL ON/OFF TOGGLE
SWITCH
The
generator control ON/OFF switch
engages the AC
generator. When off, the outlets are de-energized.
2.6.10 AC VOLTAGE OUTLETS
The
AC voltage outlets
allow for AC generator power
access via two 120V, and one 240V receptacles.
2.6.11 CIRCUIT BREAKER OVERLOAD TRIP/ RESET
BUTTONS
The
reset-capable circuit breakers
are used to protect
the generator circuits from damage if an overload or short
