EN
This product is suitable for installation in zones:
2
&
Outside Zone
All installations must comply with guidelines which are based on a zonal
concept. The diagram above illustrates this concept and must be followed
to ensure the safe installation of electrical appliances in the bathroom. These
regulations apply to domestic installations only. Installations must be made
in accordance with the current IEE wiring regulations and relevant building
regulations.
We recommend that all electrical bathroom products should
only be fitted by a suitably qualified, Part P registered electrician.
R180410 Ver No. 1.0 April 2018
Mounting Points Diagram (Fig. A)
Hanging Landscape
REAR VIEW
mounting points
Wiring Diagram (Fig. B)
Live is Brown
Neutral is Blue
live
earth
neutral
Live supply can be Red or Brown
Earth supply is Green and Yellow
Neutral supply can be Blue or Black
LUMINAIRE
MAINS SUPPLY
WEEE compliance
Must not be mixed with general household waste
Illuminated Mirrors
Bello 40
Art No. 221121
Bello 50
Art No. 221122
Bello 60
Art No. 221123
Bello 70
Art No. 221124
Bello 80
Art No. 221125
Bello 90
Art No. 221126
Bello 100
Art No. 221127
Bello 120
Art No. 221128
Bello 140
Art No. 221129
Bello 160
Art No. 221130
Bello 180
Art No. 221131
Bello 200
Art No. 221132
Thank you for purchasing this product.
Please read through these instructions carefully and refer back to them
during installation to ensure that your product is fitted safely and that it
retains its high quality finish.
Please retain this leaflet for future reference.
Before installation, ensure the domestic electrical mains supply to which
the mirror is to be connected is turned off. Before drilling, ensure that
there are no hidden cables or pipes in the wall.
Installation
1.
Position the mirror in a suitable location (according to the zonal
diagram - Fig. 1), ensuring that the domestic electrical mains
supply is within reach of the cable connection point of the
product.
2.
Carefully mark the position of the mirror using a soft pencil
ensuring it is level. Remove the mirror and mark the mounting
points (see Fig. A)
Please ensure that all marked mounting
points accurately match up with the fixing points on the
mirror.
3.
Using a suitable drill bit, drill holes in the marked positions to a
suitable depth. If drilling through tile, use a ceramic drill bit.
4.
Insert wall plugs level with the surface of the wall. If fitting to a
tiled surface, wall plugs should be inserted below the tile surface
to avoid cracking.
NB. For plasterboard walls, specialist fixings
should be purchased, available from any DIY or hardware store.
5.
Screw supplied fixings into wall plugs.
6.
Ensure the domestic electrical mains supply to which the
mirror is being connected is turned off.
Connect the domestic
mains supply to the terminal box according to the wiring diagram
opposite (Fig. B).
7.
Hang the mirror in position.
8.
Switch the domestic electrical mains supply for the mirror back
on.
Operation Instructions
To turn illumination on Touch the sensor once.
To change the colour temperature, touch and hold the sensor until
desired colour is obtained. The colour temp is then set until changed
again.
Heated Pad is only on when mirror is illuminated.
Care Instructions
Do not use abrasives or solvents when cleaning this product.
Wipe off all water spillages as soon as possible using a soft, damp cloth.
Aftercare Service
In the unlikely event that this product should fail please contact our
customer service team.
H
a
ng
in
g
P
o
rt
ra
it