MS-350 NP Operating Instructions Ver 4.02E
15
Insert the touch switch male plug securely into the
female socket located on the right side of the machine,
when facing toward it.
1
Slightly loosen two wing bolts.
2
Insert the L-shaped table corner into the gap
between the unit frame and the wing bolts.
3
Tighten the bolts firmly at the height suitable for
your product.
[Withstanding weight: 2kg]
The power cord is located on the right side of the
machine, when facing toward it. See the label attached
to the machine to determine the proper voltage and
electrical power. Make sure the electrical outlet has
adequate current carrying capacity. Insert the electric
power plug fully into the power outlet.
8-2 Table attachment
8-3 Touch switch attachment
8-4 Plugging in the electrical power cord
Wing bolt (M6 x 15)
Touch switch
male plug
Attention
Do not fix the table higher than the
seal surface.
Warning
Caution
Attention
Always use the AC power cord
designated by
Van der Stahl Scientific.
There is a danger of fire if the electrical
power source does not meet proper
specification.
Do not use an extension cord and a
multiple outlet adapter since they may
cause the voltage drops.
When inserting the power cord socket and
plug, make sure that the inlet module
power switch is in OFF position.
If the power switch is ON, it turns OFF
automatically. This is not a malfunction.
