Van der Ende Groep · Aartsdijkweg 23, 2676 LE Maasdijk, the Netherlands
+31 174 515 050 · [email protected] · www.vanderendegroep.com
Page 12 of 26
IMPROVING YOUR BUSINESS
4.4.3 Assembling the shaft guide (only required for shaft length >1m)
1.
Open the package containing the shaft guide (E); take all the parts out of the package
and arrange them clearly and carefully.
2.
Remove the four locknuts attaching the basic frame (2) to the motor mounting tray (6);
leave the bolts in the frame.
3.
Place the frame upside down, ensuring that the bolts stay in the frame.
4.
Now take out the bolts attaching the basic frame (2) to the motor mounting tray (6),
ensuring that the parts remain positioned in such a way that the bolts can easily be re-
inserted.
5.
Now place the shaft guide (7) on the frame correctly and re-insert the bolts that you just
took out.
6.
Attach the shaft guide (7) to the front of the motor mounting tray (6) using the following
parts. Insert the following bolts from the shaft guide (7) side.
o
2x bolt m8x10
2x fender washer m8
7.
Attach the two bolts to the corners of the shaft guide (7) using the following parts. Insert
the following bolts from the outside of the shaft guide (7).
o
2x bolt m8x10
2x fender washer m8
8.
Attach the plate bush + slide bearing (9) to the shaft guide (7) using the following parts.
Ensure that it is attached correctly; see Figure 4.
o
2x bolt m8x25
4x fender washer m8
2x locknut m8
9.
Tilt the frame back again, so that it is resting on the shaft guide (7) and one side of the
frame.
10.
Firmly tighten the four locknuts that hold together the shaft guide, the basic frame and
motor mounting tray.
11.
The frame will now look as shown in Figure 4.
Figure 4: Frame including the shaft guide