www.valuehobby.com/aviator-trainer-40-arf.html
10
Step3. Locate the items shown in the picture.
Step4. Use the hobby knife to remove the
coverings to expose the holes on the wing and
wing bolt plate.
Step5. Install the wing to the fuselage using two
M4*35mm (1.4inch) screws and two M4 washers.
Section4. Tail Set Installation
Step1. Attach the elevator to the horizontal
stabilizer using the same way in section 1.
Step2. Slide the horizontal tail into the slot at the
rear of the fuselage. Check to make sure the
horizontal tail is centered in the fuselage as shown
below.
Step3. Double-check the alignment to satisfy the
requirement shown below.
