www.valuehobby.com/aviator-trainer-25-arf.html
10
Step3. Locate the items shown in the picture.
Step4. Use the hobby knife to remove the
coverings to expose the holes on the wing and
wing bolt plate.
Step5. Install the wing to the fuselage using two
M3*30mm (1.2inch) screws and two M3 washers.
Section4. Tail Set Installation
Step1. Remove the covering for the slots on the
fuselage and horizontal stabilizer.
Step2. Attach the elevator to the horizontal
stabilizer using the same way in section 1.
Step3. Position the horizontal tail and fin in the
fuselage.
(Note: Make sure the horizontal stabilizer is
centered in the fuselage and the measurement
from stabilizer tips to wing tips is equal. Also check
the horizontal stabilizer is parallel with the wing
and the fin is perpendicular with the stabilizer.)
