•
To adjust the height of the mudguards, change the fixing screws or the shafts
to the other holes.
In addition, the mudguards can be inclined forward and backward in their
fixing holes.
NOTE:
The distance between the fixing screws must be as wide as possible. Use the
highest and lowest possible holes for the fixing screws.
4.8.10
Towing devices
4.8.10.1 Adjusting lifting links of the pick-up hitch
Adjust the lifting links of the pick-up hitch if needed.
The lifting height selector must be in the maximum position when the towing hook
is unloaded.
GUID-870906B0-14AF-4CB0-8F19-C1A5FF720C16
The lifting links must always have a certain amount of clearance when the rear
linkage is in its upper position. However, they must be adjusted in such a way
that the pick-up hitch is securely locked by the pawl, even when the towing hook
is loaded.
1. Raise the rear linkage to its upper position.
Use the lifting/lowering switch.
2. Check the adjustment by moving the lifting links manually.
The adjustment is correct when the links are slightly tensioned. When the
linkage is lowered, the towing hook is locked positively by the pawl.
3. Make sure that the spring returns the pawl completely.
4. If necessary, adjust the length of the links by removing the cotter at the upper
end of the links and turning them until the correct length is obtained.
The link shortens when turned clockwise and extends when turned
anticlockwise.
4. Maintenance
- 409 -
