2
3. KIT COMPONENTS
The kit contains the following (fig. 3):
•
1
top panel.
•
1
rear panel with spacers.
•
1
right side panel with spacers
•
1
left side panel with spacers.
•
1
base panel.
•
2
top panel spacers.
•
1
inlet opening cover plate.
•
1
extension bracket for thermostat coil.
•
1
screw pack.
•
4. ASSEMBLE THE ZERO CLEARANCE KIT
•
Assemble the rear, two sides, top and base panels, to form the zero
clearance box, using the screws provided, (see fig. 3)
•
Fit the top spacers to the top panel using the screws provided(fig. 3).
•
Fit the inlet opening cover plate to the rectangular opening which will not be
used for the gas inlet pipe.
•
Secure the kit to the framing. Two fixing holes are provided in the base.
Alternatively the side flanges may be drilled and countersunk woodscrews
used.
•
Fit the flue pipe through the hole in the top panel and secure to the appliance
vent connector as described in the appliance instructions.
•
All wall and hearth finishes can now be applied.
•
5. INSTALLING THE APPLIANCE
•
Detach the thermostat coil from securing
bracket at right side of appliance (see fig. 5).
•
Fit the thermostat coil extension bracket to the
end of the existing bracket with the two screws
provided (fig. 6).
•
Secure the thermostat coil to the tab at the top
right of the extension bracket.
•
The unit can now be installed exactly as in a
masonry fireplace, see the appliance installation
guide.
If the appliance does not have a thermostat coil
bracket, work through the following steps
•
Detach the thermostat coil from the securing clip at the right side of the
appliance.
•
Bend thermostat extension bracket along perforated line through 90º (see
fig. 7).
•
Fit the thermostat coil extension bracket to the two holes with the 2 screws
provided. (see fig. 7).
•
Secure the thermostat coil to the tab at the top right of the extension
bracket.
•
The unit can now be installed exactly as in a masonry fireplace, see the
appliance installation guide.
Fig.3
Fig.7
Fig. 4
Fig. 5
Fig. 6