3
Early models—Burner fi xing nuts
accessible from underside of module
Later models—Burner fi xing supports
accessible from the top of module
Early models:
The burner fi xing points are under the
burner module tray and the burner module assembly
must be removed. Proceed as follows:
1. Remove the screw retaining burner module tray on
the right hand side as well as the 12 screws retaining
the module plate at the left side wall of the fi rebox—
see fi gure 1.
2. Grab the burner module assembly, lift it slightly, twist
it upward and slide it towards the right and out to
allow the valve and receiver attached to the module
end plate through the left inner fi rebox wall as shown
below.
3. Remove the front log retaining bracket from the
burner top at the right hand side and the injector
elbow with air shutter (NG) from the end of the
burner. Note that there is no air shutter on the LPG
burner. Unscrew the pipe nut while holding the
injector elbow with a wrench—see fi gure 2.
4. Remove the main burner by removing the two nuts
from the underside of the burner tray.
5. Replace the main burner by the appropriate fuel
burner fi xing it back to the burner tray with the two
nuts.
Later models:
The burner is fi xed to the burner tray
through two supports. The conversion can be done
without removing the burner module assembly from the
fi rebox.
1. Remove the front log retaining bracket from the
burner top at the right hand side.
2. Remove the injector elbow with air shutter (NG)
from the end of the burner. Note that there is no air
shutter on the LPG burner. Unscrew the pipe nut
while holding the injector elbow with a wrench—see
fi gure 2.
3. Remove the main burner by removing the fi ve
screws retaining the burner supports to the burner
tray.
4. Detach the main burner from its supports and attach
the supports to the replacing burner.
5. Refi t the new main burner to its position by fi xing the
burner supports back to the tray with the fi ve screws
previsously removed.
Remove burner from
tray (5 screws)
Remove front log retaining
bracket (2 screws)
Removing burner module from fi rebox
(fi rebox front transparent for clarity)
1
2
Burner
Remove front log
retaining bracket
Unscrew injector
elbow with air
shutter (NG) from
end of burner
Unscrew pipe
nut while holding
injector elbow
with wrench
1
2
3
Figure 2
