on the inlet ‘T’ connector. See figure 19. Check the
pressure with the appliance alight and set at
maximum output.
2.
After checking, turn off the appliance. Remove
the pressure gauge and replace the test point sealing
screw.
3.
Relight the appliance. Turn to the maximum
output position and test around the sealing screw
for gas soundness with a suitable leak detection
fluid.
10.4 Fitting the burner tray trim.
1.
Fit the burner tray trim over the front rim of
the burner tray. Push the trim fully down. See
figure 20
11. FITTING THE FRONT SURROUND
11.1 Fitting The Quantum Front Surround.
1.
Place the surround on top of the plinth.
Be careful not to drag the surround
across the top surface of the plinth as this
will scratch the plinth. Secure the
surround to the plinth using the two
screws supplied (See Figure 21).
2.
Fit the surround to the appliance by
locating the top to the upper hanging
bracket (Figure 22), then attaching it to
the body of the appliance using the two
screws supplied (Figure 21)
3.
Fit the lower hanging trim to the
surround (Figure 23)
Page 24
INSTALLER GUIDE
Figure 21. Fitting surround
Figure 20. Burner Tray Trim
Figure 19. Pressure test point
