Valor Retrofire F24BN, Installation And Owner'S Manual

Page: 19 / 26

19
Remote Control Operation
CAUTION
DO NOT USE a screwdriver or other metallic object
to remove the batteries from the receiver or the
handset! This could cause a short circuit to the
receiver.
Setting the temperature
Use this setting when you come in and want to enjoy a specific temperature.
1. Push the
AUTO button until a number and F flash. Let go.
2. While it is still flashing, push the ▲ and ▼ buttons to the temperature you want.
Let go.
Your fireplace will reach that temperature and the remote will check the temperature
every five minutes, adjusting the amount of fuel needed to give you a steady, even heat.
Setting the flame
Use this setting when you want a particular flame level. For instance, you want to
watch flames burn at their highest level and you don’t mind if the room is too hot.
1. To raise the flame, press and hold the ▲ button until the flame gets to the desired
level. Let go.
2. To lower the flame, press and hold the ▼ button until the flame gets to the
desired level. Let go.
The flame level will remain just as you set it.
Programming time and temperature
You can set your fireplace to come on before you wake up and turn off after you leave
and then, turn on again just before you come home and turn off after going to bed.
You can leave it like this for the heating season.
1. Decide what temperature you want your fireplace to be at. Also, decide what time
you want your fireplace to turn on and off. Finally, decide what time you want it to
come back on and off in the afternoon or evening. For the first few times you set
the timer, it’s handy to write these times down.
2. Set the temperature (just as you did in the section
Setting the temperature.)
3. Press the TIMER button and hold it until P1 ☼ appears and flashes. Let go.
While flashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at
which you want your fireplace to turn on in the morning.
4. Press the TIMER button and hold it until P1 ☽ appears and flashes. Let go. While
flashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at which you
want your fireplace to turn off when you leave.
5. Press the TIMER button and hold it until P2
☼
appears and flashes. Let go. While
flashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at which you
want your fireplace will turn back on in the afternoon.
6. Press the TIMER button and hold it until P2 ☽ appears and flashes. Let go. While
flashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at which you
want your fireplace to turn off in the evening.
7. That is all you have to do. Your fireplace will give you steady, even heat at the
temperatures and times you set.
Note: If you want to set your fireplace for only one time on and off, set P2
☼
and P2
☽
for the same times as P1
☽
. The remote will record the P1
☽
off time for both P2 times.
To temporarily override the timer setting, just press AUTO or ▲ and ▼ to go back to
manual settings. Press TIMER to go back to your settings.
Battery Replacement
When your remote control displays BATT , you need to
replace the battery with a new 9 volt alkaline battery—
6LR61/MN1604.