6
Casting Side Panels
1. On the casting side panels, release the top and
bottom screws.
2. Drop a hinge pin on the back corner of base and
drop the side panel on the pin.
3. Rotate the panel towards the engine.
4. Repeat with the other casting side panel.
Fixing Casting Side Panels & Engine
1. Adjust the position of the engine to locate the top
and bottom screws of the side panels into the
slots of the engine’s side bracket. Tighten the top
and bottom screws.
2. Adjust the engine as required and fix it to the casting
base at bottom of its side brackets with the nuts
and bolts provided.
Top Spar
1. Position the top spar on the side brackets located
between the engine and the cast sides.
2. Secure the spar with two 3/8” pre-assembled screws
provided.
Complete engine installation
Refer to the engine installation manual for the following
steps.
1. Reposition the lighting instructions plate, remote
control receiver and connect gas line to the inlet
pipe.
2. Install the fan, if used, and convert the top outlet to
a rear outlet or co-linear outlet if necessary.
3. Install venting system.
4. Connect the gas and install the logs.
5. Refit the window and the hot glass warning plate.
6. Set up the remote control and check operation.
Front Installation
Hook the cast front
to the side brackets
located between the
engine and the cast
sides.
Cast front
Hook
Details
Engine
Side bracket
2
3
