Valor LEGEND G4 780JN (NG), Installation And Owner'S Manual

Page: 8 / 46

Owner’s Information
Replacing Batteries
Low battery signal: see page 15.
BEFORE changing the batteries, disconnect the
battery box from the receiver
.
The appliance uses four 1.5 V AA alkaline batteries
for its battery box and one 9 V alkaline battery for its
handset. Batteries should last one to two seasons,
depending on usage. Removing the batteries in the off-
season will extend the battery life. Should the batteries
loose power, the control may be operated by manually
turning the control knob at the valve or by turning off
the valve at the switch.
To replace the batteries in the battery box :
1. The battery box is located to the left of
the fi rebox behind the left access door.
Remove the left access door. Grab
the battery box and pull it out from its
location.
2. Disconnect the battery box.
3. Remove the box cover (1
screw).
4. Replace the 4 AA batteries.
5. Replace the cover and screw in place.
6. Reconnect the battery box.
7. Put the battery box back in its position.
8. Reinstall the left access door.
Locating Lighting, Operation and Rating
Information Plate
The Lighting, Operation and Rating information plate is
located at the right of the
fi rebox. To access the plate,
remove the right hand side door, grab the plate and
take it out to read it. There is important information on
both sides of the plate.
Servicing Your Fireplace
If any attention is required for your appliance, contact
your supplier quoting the model number. It will be helpful
if the appliance’s serial number can also be quoted. This
number is on the rating plate, which is located at the
right of the
fi rebox. The replacement parts are shown
at the end of this manual. Please always quote the part
number and description when requesting spare parts.
Fireplace Control Devices
There are three ways to control your fi replace.
1. Thermostatic Remote Control;
2. Wall Switch (optional);
3. Manual On/Off Switch.
The manual On/Off switch must be ON for the fi replace
to function. It can be used to shut off the fi replace in
case of emergency—see next sub-section.
The Thermostatic Remote Control can be programmed
to function automatically—see pages 10–15.
The Wall Switch (optional) can be used to turn on, off
and to increase or decrease the
fl ame height—see
1265WSK—Wall Switch Kit.
NOTE: The remote control in the AUTO mode will
override the wall switch.
WARNING
DO NOT ATTEMPT TO TOUCH THE DATA PLATE
WHILE THE FIREPLACE IS STILL HOT!
Let the
fi replace cool fi rst before touching it.
Wall Switch
(optional)
Manual On/
Off Switch
Thermostatic Remote
Control
CAUTION
DO NOT USE a screwdriver or other metallic object to
remove the batteries from the receiver or the handset!
This could cause a short circuit to the receiver.
WARNING
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT!
Let
the fi replace cool fi rst before touching it.
Battery
box
8
OWNER’S
INFORMATION
WARNING
!
WARNING
!