40
Note
Use of V2 log sets may increase the possibility of
soot formation when the air shutter is closed. The
L1 units are fitted with an air shutter stopper to
prevent closing the aeration completely in order
to prevent sooting in most situations. However, it
is still possible that some sooting may occur under
certain conditions.
Evaluate the flame picture carefully after the unit
has warmed up for fifteen minutes, and avoid
closing the air shutter completely when there is
limited rise in the venting system or the flame
appears overly luminous and lazy with smoke
trailing off the flame tips.
Refer to “Checking Operation and Aeration” on
page 57 for details about aeration adjustment.
Installation
Fuel Beds
Installation
Carefully unpack the kit. Note each log has its own
number stamped on the bottom. Some logs have pegs
to help you place them on other logs or the platform.
1. Install the steel platform around the burner as
indicated. The openings in the platform should be
underneath.
2. Place log L30 with the pin inserted in the hole as
shown. Put the other end of the log on the pilot
shield.
3. Place log L2 with the pin inserted in the hole in L30
as shown, across the burner to the front of the
media platform.
L30
L2
L30
Birch Log Kit 1505BLKV2
Material Required
• Steel platform (supplied with
fi
replace)
• 1505BLKV2 Birch Log Kit, which contains:
• 8
logs
• 1 bag of embers (6 cup bag)
• Gloves, if desired
L30
L2
L12
L31
L1
L6
L4
L32
Installed platform
