3
hours
minutes
Handset / Receiver Match
The remote control handset and receiver are
programmed to function together. In case of a
replacement of the handset or the receiver, you will
need to reset the receiver to allow them to function
together. Contact your dealer for details
Low Battery Indication
Remote handset:
BATT
will appear on the display
when the battery needs to be replaced.
Replace with one 9 V
alkaline
battery.
Receiver:
Frequent ‘beeps’ for 3 seconds when the
motor turns indicate the batteries need to be replaced.
Replace with four 1.5 V
alkaline
batteries.
NOTE:
With very low battery, the valve shuts off the fi re
completely. This does not happen when the power sup-
ply is interrupted.
CAUTION
DO NOT USE
a screwdriver or other metallic object
to remove the batteries from the battery box or the
handset! This could cause a short circuit.
Designed and Manufactured by / for
Miles Industries Ltd.
190–2255 Dollarton Highway, North Vancouver, BC, CANADA V7H 3B1
Tel. 604-984-3496 Fax 604-984-0246
www.valorfi replaces.com
Because our policy is one of constant development and improvement, details may vary slightly from those given in this publication.
FLAME HEIGHT ADJUSTMENT
The fl ame height can be adjusted in
the following manners:
Press (large fl ame) button to turn
on the main burner.
Press (large fl ame) button to
increase fl ame height
Press (small fl ame) button to
decrease fl ame height or go to pilot
For fi ne adjustments, tap the and
buttons.
Note: While pressing either button
a symbol indicating transmission
appears on the upper right hand
corner of the display. The receiver
confi rms transmission with an
acoustic signal.
SETTING ºC/24-HR OR ºF/12-HR CLOCK
To set the time, follow the steps below.
1. The display indicates °C/24-hour or
°F/12-hour clock. To change from
one to the other, press and hold
both the
OFF
and buttons until
the display changes.
2. To set the time, hold down
both
the
and buttons until the display
fl ashes. Let go.
3. Quickly press the button to set
the hour and the button to set the
minutes.
Note: You must start setting the time
while the display is fl ashing. If it stops
fl ashing, go back to 2.
4. Press the
OFF
button.