Installation Instructions
This section describes how to set up your fi re.
Before installing this appliance in an existing chimney, we recommend that;
1. You have your chimney cleaned by a competent chimney sweep.
2. You block off the chimney fl ue.
This procedure is important for the effi cient operation of the heating unit and will also reduce heat loss up the chimney.
BEFORE YOU START
1. Ensure that all packing items are removed (read any warning labels carefully) and retain all packing for possible future
use e.g. in the event of moving house or returning the appliance to your supplier.
2. Before connecting the stove, check that the supply voltage is the same as that stated on the heater.
INSTALLATION
Place the stove against a wall and connect the stove to your electricity supply.
Connect the power cable to the appropriate power connector at the back of the fi re
Plug the power cable into a 13amp/240volt outlet.
Operating the Fire
This section describes how to activate your fi re using either the manual controls or remote control.
MANUAL CONTROLS
The manual controls are located inside the stove door on the right hand side. Open the door to access the controls. (See
Fig. 2a for Manual Control layout)
The main switch controls the electricity supply to the Fire.
The switch can be pressed on either side. Please see the table below for the functions that correspond to the switching
sequence.
Switch Operation
Setting
Visual Indication
Press
Once
LED Hologram Effect On
Flame panel illuminated
Press
Once
LED Hologram & Flame Effect On
Flame movement within fl ame panel
Press
Again
Flame Effect & Half Heat On
1 Red LED behind fl ame panel
Press
Again
Flame Effect & Full Heat On
2 Red LED’s behind fl ame panel
Press
Once
Fire is turned off
Flame panel becomes darkened
Two Red LED’s as shown in Fig. 2b are located behind the fl ame panel and indicate the heat setting of the fi re. These
LED’s illuminate when a heat setting is selected and remain illuminated for aproximatly 3 seconds.
- One illuminated LED corresponds to Half Heat - 900 Watts
- Two illuminated LED’s correspond to Full Heat - 1800 Watts
REMOTE CONTROL OPERATION
The two buttons on the remote control operate in the same way as the manual switch located inside the stove door.
Operation of the remote control buttons correspond to the switching sequence in the above table.
Please note that it takes time for the receiver to respond to the remote control. Do not press the buttons more than once
within two seconds for correct operation.
Battery Information
1. Unclip the battery cover on the back of the remote control. (Fig. 3)
2. Install AAA batteries into the remote control, making sure to orient the positive and negative terminals correctly.
3. Replace the battery cover.
Discard leaky batteries
Dispose of batteries in the proper manner according to national and local regulations. Any battery may leak electrolyte if
mixed with a different battery type, if inserted incorrectly, if all the batteries are not replaced at the same time, if disposed
of in a fi re, or if an attempt is made to charge a battery not intended to be recharged.