20
Maintenance
Slide the spinner back on its metal
bracket by inserting its plactic tab
back in the bracket.
Repeat steps 2 to 6 for the second
bulb.
Replace the coal ember bed by
gently pushing it down.
Replacing the flame generation bulbs (25 W maximum)
On each side of the glass panel, there are 2 thin black metal strips.
Remove the bottom screw holding the strip in place. Lifting the top
panel above the glass, slide the strip up to unhook it and pull it out. Repeat for the other strip.
Lift the top part of black metal above the glass to reach behind it and grab the edge of the glass.
Gently pull the glass edge forward to free the top.
Lift the glass panel carefully and set it
aside in a safe place.
Locate the flame generation cylindrical
drum. Remove the screw from the half
drum.
To access the light bulbs, remove the
top half of the drum cylinder by gently
squeezing it until its edges clear their
tracks.
Note
: Do not exert excessive pressure on the drum cylinder as this
may cause damage.
Grab the light bulb at its base and pull it upward until the connecting
tips are out of the socket. Remove the bulb from its bracket.
Use a glove or tissue to handle the new bulb (25 W max.)
to avoid
damaging it with the oil of your fingers (the oil left on the bulb, when
heated up causes the glass bulb to shatter).
Insert the new bulb tip into its spring bracket, pull it upwards and insert
the connecting tips into the socket.
Repeat steps 6 to 8 for the second bulb.
To reposition the removed cylinder drum half, insert its edges into their
tracks by gently squeezing it until both
edges are fitted back into the top drum
tracks.
Fix the drum half with the screw
previously removed.
Replace the glass panel by inserting
the bottom first and then pushing its top
behind the top metal panel.
Slide back the black metal strips into place and fix them with
their 2 screws to secure the glass.
6.
7.
8.
1.
2.
.
4.
5.
6.
7.
8.
9.
10.
11.
12.
1.
Flame
generation
cylinder
drum
screw
Summary of Contents for DZ1GEC
Page 23: ...23 Wiring Diagram...