Fitting the Decorative Fascia to the Appliance
Fitting the plastic infill trim ( Petrus Model Only).
Remove the plastic infill trim from its packaging. Locate the four tabs
on the rear of the plastic infill trim into the four slotted holes on the
front of the appliance
- see Fig.11 .
Fitting the metal infill trim ( Dream Model Only).
Remove the metal infill from its packaging. Locate the metal infill trim
on the back of the Fret
- see Fig.12 .
Secure the metal infill trim in
place using the two M5 x 8 screws supplied.
Fitting the fascia.
Remove the fascia from its packaging. Holding the fascia firmly with
both hands , lift into place. Locate the fascia hanging brackets into
the slots on top of the appliance
- see Fig.13 .
Lower the fascia into
the place and swing the bottom of the fascia towards the appliance.
Secure the fascia in place by the holes in the lower side legs of the
fascia using the two washers and two M4 x 25mm screws supplied.
Fitting the fret and ash pan ( Petrus Model Only).
Remove the fret from its packaging. On the rear of the fret it maybe
fitted with hanging screws or they may be supplied in the fret
packaging. Where they are not already fitted insert them into the lower
holes on both sides of the fret
- see Fig.14.
The distance between the
fret and the underside of the screw heads should be approximately
12mm. The screws can be adjusted to obtain the required fit. Hang
the fret on the hole slots on the front of the appliance. Position the ash
pan beneath the fret.
Fitting the fret and ash pan ( Dream Model Only).
Remove the fret from its packaging. Locate the fret in front of the
appliance. Position the ash pan beneath the fret.
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORE ATTEMPTING ANY MAINTENANCE.
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORE CLEANING THE HEATER.
For general cleaning use a soft clean duster – never use abrasive
cleaners. The glass viewing screen should be cleaned carefully with a soft
cloth. There is a mirror located underneath the canopy, this may require
cleaning to ensure a sharp clear image as shown below in
Fig.15
.
DO NOT use proprietary glass cleaners.
To remove any accumulation of dust or fluff the soft brush attachment of
a vacuum cleaner should occasionally be used to clean the outlet grille
of the fan heater.
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
UK
Recycling
For electrical products sold within the European Community.
At the end of the electrical products useful life it should not be
disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling
advice in your country.
After Sales Service
Your product is guaranteed for one year from the date of purchase.
Within this period, we undertake to repair or exchange this product free
of charge (excluding lamps & subject to availability) provided it has been
installed and operated in accordance with these instructions.
Your rights under this guarantee are additional to your statutory rights,
which in turn are not affected by this guarantee.
Should you require after sales information or assistance with this product
please go to
www.valor.co.uk
where you will find our self help guide or
ring our helpdesk on 0844 879 3588 (UK) or 01 842 4833 (R.O.I.) .
Spare parts are available from the help desk.
www.valor.co.uk
Please retain your receipt as proof of purchase.
Fig.15
- DREAM DIMENSION
- PETRUS DIMENSION
