OWNER GUIDE
Page 9
To Light the Fire
The pilot must be lit using the pilot burner knob on the appliance (see figure 2).
The heat and flame settings can be controlled by either using the main burner control
knob on the appliance (see figure 2) or by using the remote control handset (See figure
4). The remote control handset operates by sending an ultrasonic beam. The handset
does not need to be accurately pointed directly at the fire.
Please note: Research has shown that the ultrasonic transmission signal will not cause
any pain or hearing damage to a domestic cat or dog but it may disrupt its normal
behaviour. We, therefore, do not recommend pointing the remote control handset at
any domestic animal or operating the device within one meter of the animal’s ear.
To light the pilot
1.
Depress the pilot burner control knob and turn anti-clockwise to the ignition
position (
2
in figure 2) to activate the piezo ignition system. A ‘click’ will be heard and
the pilot should light. Observe if it is alight by looking through the slots to the left
hand end of the front coals. If the pilot does not light immediately, repeat the above
procedure, keeping the knob depressed for several seconds in order to purge any air
from the system.
If after ten seconds, ignition has not occurred, turn the control knob back to the OFF
position. Wait 30 seconds and then repeat the ignition procedure.
2.
When the pilot is alight keep the knob depressed for ten seconds. This will
prevent the flame-sensing device from shutting off the gas while its probe warms up as
explained above.
3.
Release the knob. When the knob is released, the pilot should remain alight. If
the pilot fails to remain alight, repeat the ignition procedure, this time keeping the
knob depressed for a longer period of time.
If the pilot flame repeatedly goes out have the fire serviced.
To light the main burner
Once the pilot light is alight and stable, light the main burner by turning the pilot
burner control knob anti-clockwise to the “main burner on” position (
3
in figure 2).
To select the heat and flame setting
a)
Using the appliance manual control:
Turn the main burner control knob to
any desired setting between low (
4
in figure 2) and high (
5
in figure 2).
b)
Using the remote control handset: Press the “lower” or “higher” button to any
desired setting.
