Page 3 of 5
•
5. SECURE THE ZERO CLEARANCE KIT TO THE FRAMING
•
Place the kit in the framing. Note – bottom of the zero clearance kit should be installed
flush with the top of finished hearth. Allow for raised hearth.
•
Hook the sheet metal cement board support over the top flange and secure through two
holes. ( see fig 3 )
•
Secure the front flange of the zero clearance kit to the framing.( see fig 3 )
•
Connect 4” dia “B” type vent to the vent connector on top of the zero clearance box.
•
Attach the 4” dia flex liner to the vent connector, located on the underside of the top
panel, using one of the gear clamps provided.
•
Non-combustible material (i.e. wonder board, cement board, etc.)
must be attached to the framing and the front flanges of the zero
clearance box as shown in fig. 4.
•
All wall and hearth finishes may now be applied.
Fig.3. ZC kit installed in framing