authorised service agent, or a similarly qualified person.
All external wiring between the appliance and the electrical supply, including the earth,
shall comply with current IEE regulations.
Operating the Heater
Never cover the heater. There is a risk of fire if it is covered.
The heater is operated by three switches, located belowat the bottom left hand side of
the heater between the front and rear support leg.
Switch 1 =
O
Main On - Off
In the On position only the fuel effect operates
Switch 2 =
I
1kW fan heat setting and fuel effect
Switch 3 =
II
2kW fan heat setting and fuel effect
The switches are mechanically interlocked, so when switch 1 is turned off, all switches
turn off.
Maintaining Your Fire
Lamp Replacement
The lamp fitted to this heater are long life compact
flourescent type, but due to the indeterminate life
span and ease of replacement it is specifically
excluded from the guarantee.
To replace a lamp.
1.
To gain access to the lamp remove the
thumbscrew located at the top rear of the heater
and slide the top panel backward. This will
disengage the top panel from the heater body (See
figure 2).
Page 6
INSTALLER AND OWNER GUIDE
Figure 3. Fuel support
removal.
Always disconnect the heater from the electricity supply by removing the 3 pin plug
and allowing the heater to cool before undertaking maintenance or replacing the lamp.
