![Valor 739-72ILN/P Installation And Owner'S Manual Download Page 8](http://html1.mh-extra.com/html/valor/739-72iln-p/739-72iln-p_installation-and-owners-manual_851501008.webp)
Owner’s Information
5. Apply fi rm hand pressure around the window frame to
ensure the window is sealed tight against the fi rebox.
6.
If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
7.
Rehook the front with the barrier screen
attached.
Checking pilot and burner fl ames
A periodic check of the pilot and burner fl ames should
be made. Check after the fi re has been on for at least
30 minutes. The pilot fl ame must cover the tip of the
thermocouple probe. The main burner fl ame pattern will
vary from appliance to appliance depending on the type
of installation and climatic conditions.
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
fl ammable vapors and liquids.
Inspect the vent terminal outdoors regularly to make
sure that snow, trees, bushes, leaves, or other objects
do not obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.
Replacing Batteries
Low battery signal: see page 11.
The appliance uses four 1.5 V AA
alkaline
batteries
for its remote control receiver and one 9 V
alkaline
battery for its handset. Batteries should last one to two
seasons, depending on usage. Removing the batteries
in the off -season will extend the battery life. Should the
batteries loose power, the control may be operated by
manually turning the control knob at the valve or by
turning off the valve at the switch.
Hot Glass Plate
WARNING
FOR SAFETY PURPOSE, ensure the barrier
screen is re-installed on the fi replace front after
maintenance.
!
CAUTION
DO NOT USE
a screwdriver or other metallic object to
remove the batteries from the receiver or the handset!
This could cause a short circuit to the receiver.
WARNING
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT!
Let
the fi replace cool fi rst before touching it.
WARNING
!
Thermocouple
probe must be
in flame
Correct Flame
Picture—Logs
Pilot fl ame
Thermocouple
probe must be
in fl ame
Pilot Flame can be seen between logs
WARNING
Failure to install the window correctly can
leak carbon monoxide, aff ect the performance
of the fi replace, damage components, cause
overheating resulting in dangerous conditions.
Damage caused by incorrect window installa-
tion is not covered by the Valor warranty.
!
DANGER
The window unit must be correctly installed,
fastened and sealed after servicing or serious
bodily injury and/or damage to the appliance
may result.
To ensure a safe operation:
•
Double-check that the bottom of the window
frame is correctly installed in the bottom
support railing/tabs;
•
Verify that the bolts are hooked properly to
the window tabs then;
•
Pull out the top of the window and release it
to insure the springs return it;
•
Ensure the window is sealed before operation.
!
8
OWNER’S
INFORMATION