WARNING
!
DO NOT ATTEMPT TO CHANGE THE BATTERIES
WHILE THE FIREPLACE IS STILL HOT!
Let the
fireplace cool first before touching it.
CAUTION
DO NOT USE
a screwdriver or other metallic object to
remove the batteries from the receiver or the handset!
This could cause a short-circuit to the receiver.
Servicing & Maintenance
Replacing Batteries
Low battery signal: see page 9.
The appliance uses four 1.5 V AA
alkaline
batteries
for its remote control receiver and one 9 V
alkaline
battery for its handset. Batteries should last one to two
seasons, depending on usage. Removing the batteries
in the off -season will extend the battery life. Should the
batteries loose power, the control may be operated by
manually turning the control knob at the valve or by
turning off the valve at the switch.
To replace the batteries in the remote control
receiver
:
1. The receiver is located to the left of the valve and it
is retained to the fi rebox by a
Velcro
tab.
Grab the receiver and pull it out from its location.
2. Slide and remove the receiver cover.
3. Replace the batteries with 4 AA
alkaline
batteries.
4. Replace the cover.
5. Put the receiver back in its position pushing it in
so it attaches to the
Velcro
tab.
Using Handset Wall Holder
Your fi replace equipment includes a wall
holder to store the handset. If it hasn’t be
installed, refer to the instructions further
on in this manual for the installation.
16
OWNER’S
INFORMATION
